AEG LAVAMAT 50435 User Information page 31

Problem
Fabric softener was not
washed into machine;
drawer æ for condi-
tioner is filled with
water.
Washing is heavily
creased
Washing has not been
spun properly. Water is
left in the drum.
Remnants of detergent
are building up in the
detergent dispenser
drawer.
The rinsing water is
cloudy.
Door cannot be
opened.
Possible Cause
The conditioner insert has
not been correctly positioned
inside the conditioner com-
partment or is blocked.
Probably too much washing
was put into the drum.
Drain hose is kinked.
Maximum pump head (dis-
charge height 1 m from the
appliance's base) is exceeded.
Drain pump is blocked.
Water tap is not fully open.
The inlet hose filter in the
coupling inlet hose at the
tap is blocked.
The cause is probably a
detergent with a high silicate
content.
Door is locked for safety rea-
sons.
Operating Instructions
Remedy
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Pay attention to the maxi-
mum load quantity (see Pro-
gram tables). In the case of
easy-care fabrics, select the
EASY IRON program.
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conver-
sion kit is available as a spe-
cial accessory.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
Open the water tap fully.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the appliance.
Clean the filter.
No negative effect on the
rinse results; use a liquid
detergent if necessary.
Wait for 1 or 2 minutes after
the end of the program.
31