HP Kayak XU 03xx Troubleshooting Manual page 11

Clearing the
PC Workstation's
Configuration Memory
HP Kayak XU 03xx PC Workstation Troubleshooting Your HP PC Workstation
If the PC Workstation then starts, but POST still persists in reporting an
error, clear the current configuration memory values and reinstall the
built-in default values:
1 Turn off the PC Workstation, disconnect the power and cables, and
remove the cover. Disconnect the PC Workstation from any
telecommunications network.
a Set the system board switch 6 (CLEAR CMOS) DOWN to clear
the configuration.
b Replace the cover, and reconnect only the power cable.
c Turn on the PC Workstation. This will erase the CMOS memory.
d Wait until the PC Workstation has started. A message will be
displayed similar to this:
"Configuration has been cleared, set switch Clear
CMOS to the open position before rebooting."
e Turn off the PC Workstation, disconnect the power cable, and
remove the cover.
f Set the system board switch 6 (CLEAR CMOS) UP to retain the
configuration.
2 Replace the cover, and reconnect the power and cables.
3 Switch on the PC Workstation. An error message will be displayed
similar to the following:
On your monitor:
Incorrect PC Configuration
The PC Workstation will stop. Press
errors) and then press
4 Run Setup by pressing
automatically downloaded and saved.
5 Make any other changes you want and press
configuration and exit from Setup.
If Your PC Workstation Does Not Start Properly
On your PC Workstation's LCD:
Error! POST 0012
.
. CMOS default values will be
(to view the system
to save the
English 11