Frigidaire FRS300ESC Installation Instructions Manual page 6

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Serial Plate Location
You will find the model and
serial number printed on the
serial plate. The serial plate is
located as shown.
Remember to record the
serial number for future
reference.
3.
Electrical Connection to the
Range (U.S.A.)
This appliance is manufactured with the neutral terminal
connected to the frame.
Three Conductor Wire Connection to Range
If local codes permit connection of the frame grounding
conductor to the neutral wire of the copper power
supply cord (see Figure 4):
1. Remove the 3 screws at the lower end of the rear
wire cover, then bend the lower end of the rear
wire cover (access cover) upward to expose range
terminal connection block (see Figure 3).
BEND REAR WIRE COVER HERE
FOR ACCESS TO TERMINAL BLOCK
Figure 3
2. Remove the 3 loose nuts (after you remove the
3. Connect the neutral of the copper power supply
4. Replace the 3 nuts on the terminal block (see figure
5. Lower the terminal cover and replace the 3 screws.
Figure 2
Terminal
Block
Black
Wire
A User Supplied Strain-
relief Must Be Installed
at This Location.
6
rubber band) on the terminal block using 3/8" nut
driver or socket.
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to the
outer terminals. Match wires and terminals by color
(red wires connected to the right terminal, black
wires connected to the left terminal).
4).
To 240 V
Receptacle
Figure 4
Silver Colored Terminal
Red Wire
Cord
Mounting
Plate
Neutral
(White Wire)
Grounding
Strap
1 1/8" (2.9 cm) Dia.
Direct Connection
Hole. Punch Out
Knockout for 1 3/8"
(3.5 cm) Dia. Cord
Kit Hole.