Trim Enable (Te); Global Output Level Enable (Ge); Direct Level (Dl); Effects (Fx) - RME Audio ADI-8 QS User Manual

9.11 Trim Enable (TE)

Default: On
Available settings: On, Off
The settings of the level calibration per channel, Input Trim and Output Trim (see chapter 9.3
and 9.4), can be deactivated globally. The gain is then set to 0 dB. The individual settings are
not lost, changing between the calibrated (On) and the linear setting (Off) is possible back and
forth anytime.

9.12 Global Output Level Enable (GE)

Default: On
Available settings: On, Off
With the volume control deactivated the gain is fixed to 0 dB. Even if Direct Level is activated
SET can not be used to change the volume.
Note: This setting is also valid for the included remote control box.

9.13 Direct Level (dL)

Default: Off
Available settings: On, Off
When Direct Level is activated, turning the rotary encoder immediately changes the global out-
put level, in the same way as the included Hardware Remote. This option provides a comfort-
able setting of the volume at the unit, without the need to enter the according Setup menu first.
At each change the level meters are shortly switched off, displaying the current gain value in-
stead.
Note: The included Hardware Remote is operational even when Direct Level is deactivated.

9.14 Effects (FX)

Default: 5
Available settings: 1.5, 3, 4, 5 dB
The digital limiter can be adjusted in four steps. The display in the left
window shows the I/O ratio curve of a limiter. The picture to the left
shows the setting 1.5 dB, having the smallest effect. At 5 dB the curve
is more horizontal, indicating a stronger influence on the input signal.
User's Guide ADI-8 QS © RME
21