RME Audio Multiface User Manual page 79

A drawing showing the jumper position for each level setting is found on the left side (under-
neath the flat cable) on the analog board.
To prevent the loss of jumpers in –10 dBV mode, we recommend not to remove them com-
pletely, but to mount them at the outside of the jumper (no connection to the center pin).
Now you are ready to re-assemble the Multiface.
9. Turn the cover to the left and move it back over the Multiface.
Take care that the flat cable has the same accurate shape as when opening it. Else the flat
cable will cause mechanical problems while re-assembling!
10. Move the cover so that it is placed 2 centimeters (1 inch) above the housing. Tilt the cover
so that the jacks point to the holes in the rear panel. Carefully slide the jacks into the holes by
moving the cover away from you. When inserted completely into the rear panel, the cover can
now be layed down.
11. Re-fit the 6 screws into the cover, and re-fit and tighten both screws of the D-sub jack.
That's it!
User's Guide HDSP System Multiface © RME
79