Operate The Autoprinter; Install The Carousel; Power On And Off The Autoprinter - Rimage AutoPrinter User Manual

Operate the AutoPrinter

This section provides the information needed to operate your Rimage
AutoPrinter.

Install the Carousel

Important! To prevent errors, install the carousel before operating the
software or powering on the AutoPrinter.
1. Slide the carousel into the AutoPrinter so that the shaft slides into the
opening of the bearing guide. Refer to the
for proper carousel placement.
2. Lower the carousel so that the top support bearing drops into the
bearing guide.
3. If necessary, rotate the carousel to seat the carousel securely.
Bearing Guide
Shaft
110656_N
Front View section on page 5
Top Support Bearing
For more information visit

Power On and Off the AutoPrinter

Important! The carousel must be installed before you power on the system.
Install the Carousel
Refer to the
Tips:
• The Prism printer has a separate power switch. The Prism power
switch must be in the On position in order for the printer to power
on at the same time as the AutoPrinter.
• The Everest printer does not have a power switch. The Everest
printer powers on when the AutoPrinter powers on. The Everest
printer takes 1 to 2 minutes to complete initialization
Press the power switch on the rear of the AutoPrinter to the On
•
position.
The AutoPrinter powers on.
• Press the power switch to the Off position.
The AutoPrinter powers off.
Power Switch
rimage.com/support
section.
8