Advanced Setup - Bryant TSTATBBPQ501 User's Information Manual

Advanced Setup

This is normally done by the installer at initial installation.
Enter advanced setup by adjusting the program switch to
SET. When the clock is flashing, press NEXT for 5 seconds.
Do not release the button until this screen appears.
NEXT
6
NEXT
L I
NEXT
F
Adjust the program switch to OFF or RUN to exit
Advanced Setup.
I
Yes
Step only
appears
if connect-
ed to 24
volt power
Use these buttons to
adjust the deadband
from 1 to 6 degrees.
Use these buttons to
adjust the cycles/hour
from 2 to 6.
d=no limit (zoning)
d1=d+no compressor
lockout.
Select YES to have the
backlight always on, or NO
to turn off the backlight 8
seconds after a button press.
Use these buttons to select
thermostat operation in
degrees C or F.
If degrees C is selected two presses of the Up or Down
buttons will be required to change the setpoint.
Page 16