Replacing the power switch/ LED assembly
1. Remove the front bezel. See "Removing and replacing the front bezel" on page
2. Disconnect the power switch/LED assembly cable from the system board. See
3. Remove the power switch/LED assembly by disconnecting it from the inside of
4. Install the new power switch/LED assembly into the bezel.
5. Route the cable for the new power switch/LED assembly through the hole in
6. Reinstall the bezel. See "Removing and replacing the front bezel" on page 91.
7. Reconnect the power switch/LED cable to the system board.
8. Go to "Completing the FRU replacement" on page 116.
91.
the system board illustration for your machine type at "Identifying parts on the
system board" on page 86.
the bezel.
the chassis and to the system board.
Chapter 8. Replacing FRUs (Tower computers)
115