Brother MFC-8890DW Quick Setup Manual page 32

For Wireless Network Users
17
Confirm your network environment (Infrastructure Mode)
The following instructions will offer two methods for installing your Brother machine in a wireless network environment. Both
methods are for infrastructure mode, using a wireless router or access point that uses DHCP to assign IP addresses. Choose
a configuration method and proceed to the page indicated.
a
If your wireless router/access point does not support SecureEasySetup™, Wi-Fi Protected Setup or AOSS™,
write down the wireless network settings of your wireless access point/router.
IMPORTANT
If you do not know this information (Network Name, WEP key, WPA2-PSK (Pre-Shared Key), LEAP or EAP-
FAST) you cannot continue the wireless setup. You should see the documentation provided with your
access point or wireless router, consult the router manufacturer, or your system administrator.
Communication mode: (infrastructure)
Network name: (SSID, ESSID)
Authentication method:
(Open system, Shared key, WPA-PSK
1
WPA2-PSK , LEAP, EAP-FAST)
Encryption mode:
(None, WEP,TKIP, AES, CKIP)
Network key:
(Encryption key , WEP key
1
WPA/WPA2-PSK is a Wi-Fi Protected Access Pre-Shared Key, which lets the Brother wireless machine associate with access points using TKIP or
AES encryption (WPA-Personal). WPA/WPA2-PSK (TKIP or AES) uses a Pre-Shared Key (PSK) that is 8 or more characters in length, up to a
maximum of 63 characters.
2
The WEP key is for 64-bit encrypted networks or 128-bit encrypted networks and can contain both numbers and letters. If you do not know this
information you should see the documentation provided with your access point or wireless router. This key is a 64-bit or 128-bit value that must be
entered in an ASCII or HEXADECIMAL format.
For example:
64-bit ASCII:
64-bit Hexadecimal:
128-bit ASCII:
128-bit Hexadecimal:
Now go to
b
If your wireless router/access point supports automatic wireless (one-push) setup (SecureEasySetup™, Wi-Fi
Protected Setup or AOSS™)
Now go to
32
Item Example
Infrastructure
HELLO
WPA2-PSK
1
,
AES
12345678
2
, Passphrase)
Uses 5 text characters
e.g. "Hello" (this is case sensitive)
Uses 10 digits of hexadecimal data
e.g. "71f2234aba"
Uses 13 text characters
e.g."Wirelesscomms" (this is case sensitive)
Uses 26 digits of hexadecimal data
e.g. "71f2234ab56cd709e5412aa3ba"
Record the current wireless network settings
page 33
page 35