Brother NC-8100h User Manual page 159

When Installing BFP
®
on Windows NT4.0
and 2000 operating
systems we
recommend that you
add a ":" to the end
of the port name so
BFP1 = BFP1:
Here you can enter the
default E-mail address
NC-8100h or you can
leave it blank.
*If an address is
specified here this will
always be used as default
sending address.
During the installation you are presented with the following screen, select the default
unless you have previously installed this software. If this is the case use a port
number that has not been previously configured. Example BFP2
Figure 3 BFP Port Number
You also need to enter certain information into the printer driver dialog screen as
illustrated below.
Figure 4 Port Settings
It is very important that you enter your own E-mail address. You also need to
configure the SMTP mail server IP address or host name as illustrated above.
If in any doubt contact your Network Administrator for assistance
CHAPTER 15 Brother BFP Software
15-3
This can be the host
name or IP address of
the E-mail server