Resetting The Eeprom; Setting The Printer Settings In The Eeprom - Canon S600 Service Manual

Part 2: Troubleshooting

7.4 Resetting the EEPROM

The printer uses the total waste-ink absorption amount recorded by the EEPROM as
the basis for determining whether the waste ink is full.
Therefore, after replacing the waste-ink absorber, be sure to reset the total waste-ink
absorption amount.
Also, after replacing the control board, be sure to reset the new control board's
EEPROM and to also replace the waste-ink absorber.

7.5 Setting the Printer Settings in the EEPROM

The control board used in the printer is also used in other printers. After replacing the
control board, the printer settings for the respective printer must be set.
After setting the printer settings, check it with the service/factory test printout.
All the logic boards available as a replacement part contain printer
settings for the S600. Therefore, if the logic board was replaced in Japan,
be sure to set the correct printer settings.
2-32
S600