Canon Satera LBP8610 User Manual page 104

Message
<Auto Error Skip>
Cause and Remedy
Cause The printer received data for 2-sided printing of a
paper size (including the paper orientation) or
paper type on which the printer cannot perform
automatic 2-sided printing.
Remedy Press [
the data on each side is printed on two pages.
Cause The size of the paper loaded in the multi-purpose
tray is different from the setting for <
> specified from the computer or control
panel.
Remedy Match the size specified in <
and the size of the loaded paper, and then press [
].
Cause You are using LIPS LX Printer Driver, and you
loaded custom size paper of its long edges 312.0
mm (297.0 mm for a paper cassette) or less and
printed.
Remedy Load the paper in landscape orientation, then
print again.
Cause Paper was to be output with the printed side
facing up during automatic 2-sided printing.
Remedy Close the sub-output tray. The printer resumes
printing, and the paper is output to the output tray.
Cause There is a possibility that a used toner cartridge
that has reached its lifetime is installed.
Remedy Check if the toner cartridge is proper.
Cause The paper of the size specified in the application
is not loaded in the paper cassette or
multi-purpose tray, or the paper source for the
different paper size is selected.
Remedy Load the paper of the size selected in the
application (or the one specified by scaling
factors).
] to continue printing. However,
>
103