Changing The Light Bulb; Regulations, Standards, Guidelines - AEG U 96040-4 i Operating And Installation Instructions

The compressor does not
start immediately after
changing the temperature
setting.
Water in the bottom of
the cabinet.

Changing the Light Bulb

Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or disconnect from the
power supply.
1. To switch off the appliance, turn the thermostat knob to position "0".
2. Unplug the mains plug.
3. To change the light bulb, undo the
screw.
4. Press the light bulb cover as shown
and slide it backwards.
5. Change the defective light bulb.
6. Refit the light bulb cover and the
screw.
7. Put the refrigerator back into operation.

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured
in accordance with the appropriate standards. The necessary measures
in accordance with appliance safety legislation regulations (GSG), acci-
dent prevention regulations for refrigeration appliances (VBG 20) and
the regulations of the German Society of Electrical Engineers (VDE)
were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
– 73/23/EWG dated 19 February 1973 - low voltage guidelines.
– 89/336/EWG dated 3 May 1989
(including guideline change notice 92/31/EWG) - EMV guideline
28
Symptom
Light bulb data: 220-240 V, max. 15 W
This appliance is in accordance with the following EU
guidelines:
Possible Cause
This is normal, no error has
occurred.
Water drain hole is
blocked.
Remedy
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.