Use Of Dishwasher Salt; Setting The Water Softener - Zanussi ZDT110 User Manual

Water hardness
°dH
11 - 14
4 - 10
< 4
Setting the water softener manually (see table)

Setting the water softener

electronically (see table)
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and hold Programme selection/
Cancel button until programme light A
flashes and programme light B illuminates
with fixed light.
3. After a few seconds:
– programme light B turns off
– programme light A goes on flashing
– End of programme light starts flashing:
the number of flashes corresponds to
°TH mmol/l
19 - 25 1,9 - 2,5
7 - 18 0,71 - 1,8
< 7 < 0,7
Set switch to position 1 or
2
Adjusting the water hardness
setting
manually electronically
1
1
1
The water softener is factory set at position 2.
current level set. The flashing is repea-
ted with a pause of a few seconds.
Examples: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
4. To change the level, press the Programme
selection/Cancel button. Each time the
button is pressed the level increases (level
1 follows level 10). The End of pro-
gramme light indicates the new setting.
5. To memorise the operation, switch off the
dishwasher.
Use of salt
level 3 yes
level 2 yes
level 1 no
9