Completing The Fru Replacement - Lenovo ThinkCentre A57e Hardware Maintenance Manual

6. Turn on the computer and all attached devices.
7. Use the Setup Utility program to set the date and time and any passwords. See

Completing the FRU replacement

After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
1. Ensure that all components have been reassembled correctly and that no tools
2. Replace the cover.
3. Reconnect the external cables and power cords to the computer. See "Rear
4. If you have replaced the system board, you must update (flash) the BIOS. See
5. Some FRU replacements require the configuration to be updated. See Chapter 6,
104
Hardware Maintenance Manual
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
"Using the Setup Utility" in the User Guide.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside your computer.
connectors" on page 83.
"Flash update procedures" on page 115.
"Using the Setup Utility," on page 49.