Recalling Preset Rds Stations; Receiving Rds Regional (Local) Stations; Pi Seek Setting; Setting Pty31 (Emergency Broadcast) Reception - Alpine CDE-9850Ri Owner's Manual

Recalling Preset RDS Stations

1
Press FUNC. so that the "FUNC" indicator lights up.
2
Press 1 AF to activate the RDS mode.
3
Press FUNC. to activate the normal mode.
The "FUNC" indicator goes out.
4
Make sure that the "FUNC" indicator light goes out,
then press the preset button in which your desired
RDS station is preset.
If the preset station's signal is weak, the unit automatically
searches and tunes to a stronger station in the AF
(Alternative Frequencies) list.
5
If the preset station and the stations in the AF list
cannot be received:
When the PI SEEK setting is on (refer to "PI SEEK Setting"
on page 9), the unit searches again for a station in the PI
(Programme Identification) list.
If there are still no stations receivable in the area, the unit
displays the frequency of the preset station and the preset
number disappears.
If the signal level of the Regional (Local) station being tuned
becomes too weak to receive, press the same preset button
to tune in a Regional station in other district.
• For presetting the RDS stations, refer to the Radio Operation section.
The RDS stations can be preset in the F1, F2 and F3 bands only.
Receiving RDS Regional (Local)
Stations
1
Press MENU to select the SETUP mode, then press
MODE.
SETUP mode is activated.
BASS ENGINE SETUP
2
Press or to select the RDS REGIONAL
mode, then press MODE.
3
Turn the Rotary encoder to select ON or OFF.
In the OFF mode, the unit automatically keeps receiving the
related local RDS station.
4
Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
RETURN (OFF) BASS ENGINE

PI SEEK Setting

1
Press MENU to select the SETUP mode, then press
MODE.
SETUP mode is activated.
BASS ENGINE SETUP
2
Press or to select the PI SEEK, then press
MODE.
3
Turn the Rotary encoder to select ON or OFF.
4
Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
Setting PTY31 (Emergency Broadcast)
reception
Turn PTY31 (Emergency Broadcast) reception ON/OFF.
1
Press MENU to select SETUP mode, then press
MODE.
The SETUP mode is activated.
BASS ENGINE SETUP
2
Press or to the select ALERT PTY31
mode, then press MODE.
3
Turn the Rotary encoder to select ON or OFF.
If you set ON, emergency broadcast are received
regardless of source. "ALARM" is displayed during
reception.
4
Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
When an emergency broadcast is received, the volume
level will be automatically changed to the memorized level
in the traffic information mode.
For details, refer to "Receiving Traffic Information."
RETURN (OFF) BASS ENGINE
RETURN (OFF) BASS ENGINE
9
-EN