Reassembly Procedure; Installing The Enter Key, Select Dial Claw, Select Dial, Dial Sheet, Lens, And Rubber 4 Key - Brother PT-MT (P-touch mini ' tech Service Manual

3.2

Reassembly Procedure

[ 1 ] Installing the Enter Key, Select Dial Claw, Select Dial, Dial Sheet, Lens, and Rubber
4 Key
(1) Apply a rice-sized pinch of grease (Shin-Etsu Silicone G501) to each of the two
lubrication points on the end of the body cover which the inside of the select dial will
come into contact with, as shown below.
(2) Snap the Enter key into the select dial according to the orientation keys.
(3) Set the select dial claw to the body cover.
After setting, apply a rice-sized pinch of grease (Shin-Etsu Silicone G501) to the top
of the select dial claw, as shown below.
(4) Place the body cover upside down.
(5) Set the select dial to the body cover while aligning any low section of the inner dial
face with the top of the select dial claw.
(6) While pushing up the select dial, put the dial sheet. Secure the select dial and dial
sheet with three screws.
(7) Check that the select dial rotates smoothly.
Figure 3.2-1 Reinstalling the Enter Key, Select Dial Claw, Select Dial, and Dial Sheet
III - 10