Wireless Network Settings For The Computer And Camera; Procedures - Canon PowerShot SD430 Software & Wireless Manual

74
Wireless Network Settings for the
This chapter explains how to configure the wireless networking function to connect the camera
to the computer over a wireless connection.

Procedures

Follow the procedures below to configure the wireless settings.
Preparation
Check Your Computer's Operating Environment
Confirm that your computer's operating system is Windows XP (excluding the 64-bit
version) with Service Pack 2 or later installed.
Check Your Wireless Connection Configuration
In order to ensure that the registration procedures for the connection proceed smoothly,
confirm the network configuration for your computer and prepare it as necessary.
Check If Required Software Is Installed
Confirm that the software required for a wireless connection has been installed.
Registering the Target Device
Register the Target Device with the Camera
Connect the camera to the computer with the interface cable and register the target
device (your computer) with the camera.
Using the Wireless Networking Function
Use the Wireless Networking Function
Connect the camera and computer over the wireless connection and download camera
images to the computer or print them. See Actions Possible with the Camera
Connected to a Computer (p. 89) for the features that can be used over a wireless
connection.
The procedures in the "Preparation" and "Registering the Target Device" sections
are performed the first time you make a wireless connection. Thereafter, only the
procedures in the "Using the Wireless Networking Function" section are required.
Computer and Camera