Using The Software On The Windows Platform - Preparations; Installing The Software And Usb Driver - Canon PowerShot SD430 Software & Wireless Manual

Using the Software on the Windows
Platform – Preparations
This chapter explains the basic procedures for installing the software and connecting the
camera to a computer. Read this material before you connect the camera to the computer.

Installing the Software and USB Driver

Start by installing the software from the Canon Digital Camera Solution Disk.
• You must install the software before you connect the camera to the
computer.
• Windows XP or Windows 2000 users must log on to the computer as the
Administrator before installing the software.
• Windows XP (excluding the 64-bit version) with Service Pack 2 or later
installed is required to use the wireless networking function.
See ArcSoft PhotoStudio (p. 107) for details on how to install ArcSoft
PhotoStudio.
Items to Prepare
• Your camera and computer
• Canon Digital Camera Solution Disk
• Interface cable supplied with the camera
Installation Procedures
1
Confirm that the camera is NOT connected to
the computer.
If it is, disconnect the cable. The software cannot
be properly installed if the camera is connected to
the computer at the start.
2
Close any programs that are running.
13