3. Locate the memory connectors. See "System board connectors" on page 121.
4. Remove the memory module being replaced by opening the retaining clips as shown.
5. Position the replacement memory module over the memory connector. Make sure the notch
memory module aligns correctly with the connector key
module straight down into the connector until the retaining clips close.
6. Go to "Completing the FRU replacement" on page 141.
.
Chapter 10
Replacing FRUs (Types 7066, 7098, 9352, 9359, 9482, 9487, 9622, 9704, 9785, 9794, 9807, 9859, 9952)
2
on the system board. Push the memory
1
on the
125