Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual page 86

ip rtp compression-connections
ip rtp compression-connections
To specify the total number of Real-Time Transport Protocol (RTP) header compression connections that
can exist on an interface, use the ip rtp compression-connections interface configuration command. To
restore the default value, use the no form of this command.
Syntax Description number
Defaults 16 connections
Command Modes
Interface configuration
Command History Release
11.3
12.0(7)T
12.1(4)E
12.2(8)MC2
12.2(14)S
12.2(15)MC1
12.3(11)T
12.2(15)MC2h
Examples The following example changes the number of RTP header compression connections supported to 150:
interface serial 0
encapsulation ppp
ip rtp header-compression ignore-id
ip rtp compression-connections 150
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
5-6
ip rtp compression-connections number
no ip rtp compression-connections
Number of RTP header compression connections the cache supports, in the
range from 3 to 1800. The default is 16 connections.
Modification
This command was introduced.
For PPP and High-Level Data Link Control (HDLC) encapsulation, the
maximum number of connections increased from 256 to 1000.
For Frame Relay encapsulation, the maximum number of connections
increased to 256. The maximum value for Frame Relay is fixed, not
configurable.
This command was supported on Cisco 7100 series routers.
The upper limit for the MWR 1941-DC is set at 1000.
This command was integrated into Cisco IOS Release 12.2(14)S.
This command was incorporated in Cisco IOS 12.2(15)MC1.
This command was incorporated in Cisco IOS 12.3(11)T.
The upper limit for MWR 1941-DC is set at 1800.
Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
OL-11503-01