Bissell Steam Mop 90T1 SERIES User Manual page 8

O
perations
Cleaning hard floors continued
Important: Sanitizing on timber floors
is not recommended as prolonged
application of steam in one area
increases the risk of damage to the sur-
face treatment on timber floors, espe-
cially in areas with regular foot traffic
and direct sunlight, which will wear
down timber floor surface treatments
making it more susceptible to steam
damage. See CAUTION on page 7.
3. When the Steam mop stops emitting
steam, turn the unit off and unplug it.
Simply remove the water tank, refill,
plug back in, and continue cleaning.
Carpet Refresher Attachment (select models)
This accessory is recommended for the
refreshing of carpets. Once the Steam Mop
is cradled in the carpet refresher attach-
ment, it will easily glide over the carpet.
NOTE: Always be sure a mop pad is in
place before placing in carpet refresher
attachment. Only white mop pads
should be used with the carpet attach-
ment. Do not use carpet attachment on
spots or stains, or glide it over the same
spot for longer than 20 seconds.
1. Attach the mop pad to the swivel mop head.
As directed in step 1 on page 6.
2. Place the swivel mop head, with mop pad
attached, in the carpet refresher attachment.
Note: The Steam Mop rests in the carpet
refresher attachment and may not stay
attached to the swivel mop head. It is
meant to glide over the carpet.
3. Fill the water tank with water. Begin refreshing
your carpet or rug by pushing the Steam Mop
in a forward and backward motion, releasing
steam as you go.
4. When you have finished refreshing your
carpet or rug, unplug the steam mop and
remove from the carpet or rug.
NOTE: Move the Steam Mop and car-
pet refresher attachment in a continu-
ous motion until you are finished. This
product is not intended to be used as a
carpet cleaner, only a carpet refresher
or deodorizer. Never attempt to use
the Steam Mop on carpet without the
carpet refresher attachment in place.
DO NOT leave the mop in a stationary
position.
8
w w w . b i s s e l l . c o m
NOTE:
Upon first use of the Steam
Mop or first use of a new water
filter, the pump may make a
"KNOCKING" sound while the
water filter fills with water. This is
normal and will last between 30
seconds to a minute. Continue
to depress the trigger until the
"KNOCKING" subsides and the
unit begins emitting steam.
2
3