Black Widow BW 550 Installation Manual page 11

Problem
System will not enter Code
Learning Mode.
Parking lights do not flash.
Door locks do not lock or
unlock correctly, or action is
reversed
Illuminated Entry does not
activate on upon unlock.
TROUBLESHOOTING CONTINUED
Probable Cause
Ignition was not left in the on
position after turning it on &
off three times; Sequence not
performed rapidly enough (5
sec.); Valet switch is defective
or not plugged in.
Wrong
Wrong polarity selected, or
RED Wire #1 not connected
to battery power.
Defective GREEN or BLUE
wire in door lock connector
plug, GREEN and BLUE wires
reversed, or wrong door lock
wiring diagram used.
External relay required, or
Wrong polarity wired for
relay.
wire connected,
11
Suggested Correction
Leave ignition in on position;
Repeat procedure quicker;
Replace valet switch.
Connect WHITE wire to
proper wire, Reverse jumper
polarity (see Jumper Settings),
Connect RED wire #1 to +12V.
Check GREEN and BLUE wires
on door lock connector plug;
Verify vehicle's type of door
lock system; Reverse wiring to
door relays.
Add relay (see Relay Wiring
Diagrams; Reverse relay polar-
ity.