Programmable Features - Black Widow 1 Channel Installation Manual

PROGRAMMABLE FEATURES

To program these specific features
follow the procedure:
1. Anti Car Jacking: Turn the ignition
key to the ON position.Within 5 seconds
press and hold button #2 for 5 seconds.
When Anti Car Jacking is enabled, the
siren will chirp once.When disabled it will
chirp twice.
2. Current Sensor: Turn the ignition key
to the ON position, within 5 seconds
press and hold button #1 for 5 seconds,
when current sense is enabled siren will
chirp once, when disabled it will chirp
twice.
3. Shock Sensor: Turn the ignition key
to the ON position, within 5 seconds
press and hold buttons #1 & #2 for 5
seconds, the siren will chirp 5 times after
3 seconds.The system is now ready to
learn the impact. Hit the car with the
same level you want to trigger the alarm.
After learning the impact level, the siren
will sound a burst of chirps confirming it
has learned the impact level.
4. Temporary Remote Trigger Bypass:
If you wish to have the system ignore the
door inputs, but wish to have the starter
disable feature engaged:
a. Press Button #1, you will hear a nor-
mal arming chirp, (as long as arming
chirps are on).
b. Within 5 seconds press Button #2, you
will hear a second short chirp, confirming
that all inputs will not be monitored.
Once you disarm and rearm, the doors
will be monitored normally.
5. Code Learning Mode: If you wish to
"teach" the system different remote
controls:
a. Make sure system is disarmed or in
valet mode,
b. Turn the ignition switch on 5 times
within 5 seconds and leave it in the on
position (ON, OFF, ON, OFF, ON, OFF,
ON, OFF, then ON), you will hear one
chirp from the siren, the LED will flash
one time,You must press all of the arming
buttons on all transmitters that you
desire to operate.You will hear a chirp
after the system has learned each remote
control.The system will hold 3 different
codes in memory.
c. Siren will chirp after 5 seconds to exit
learn mode. If the green wire is not con-
nected to the ignition switch, touch wire
to 12V+ five times within 5 seconds.
NOTE: Once you enter the code learn-
ing mode, the system will throw out any
previously programmed remotes. If you
are programming two remotes with the
same code, the system will acknowledge
only the first remote. Even though both
remotes will operate the system.
6. Silent Arm/Disarm: If you wish to
arm or disarm your alarm, but do not
want the siren to chirp:
a. Press Button #2 momentarily.This will
temporarily delete the arm or disarm
chirps. Chirp can only be heard if standing
right next to the vehicle. Chirps will be
muted for one complete cycle (arm/disarm).
2