Ssid And Wep/Wpa Settings Setup Form - NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual

ProSafe Wireless-N Access Point WNAP210 Reference Manual

SSID and WEP/WPA Settings Setup Form

For a new wireless network, print or copy this form and fill in the configuration parameters. For an
existing wireless network, the person who set up or is responsible for the network can provide this
information. Be sure to set the regulatory domain correctly as the first step.
• SSID: The service set identification (SSID) identifies the wireless local area network.
NETGEAR_11ng is the default WNAP210 SSID. However, you can customize it by using up
to 32 alphanumeric characters. Write your customized SSID here.
___________________________________
Note: The SSID in the wireless access point is the SSID you configure in the wireless adapter
card. All wireless nodes in the same network must be configured with the same SSID.
• Authentication.
Circle one: Open System or Shared Key. (Choose Shared Key for more security.)
Note: If you select Shared Key, the other devices in the network will not connect unless they
are set to shared key as well and have the same keys in the same positions as those in the
WNAP210.
• WEP Encryption Keys.
Circle one: 64, 128, or 152 bits. (Enter all four 802.11b/g/n keys for the key size chosen.)
Key 1: ___________________________________
Key 2: ___________________________________
Key 3: ___________________________________
Key 4: ___________________________________
• WPA-PSK (Preshared Key)
Record the WPA-PSK key ___________________________________
• WPA RADIUS Settings. For WPA, record the following settings for the primary and
secondary RADIUS servers:
Server Name/IP Address: Primary _________________ Secondary __________________
Port: ___________________________________
Shared Secret: ___________________________________
___________________________________
2-26
v1.0 March 2009
Installation and Configuration