Wireless > Basic Wireless Settings - Cisco WRT54GS - Wireless-G Broadband Router User Manual

Chapter3
Setup > Advanced Routing (Router)
Advanced Routing
Operatng Mode Select the mode in which this Router
will function. If this Router is hosting your network's
connection to the Internet, select Gateway. If another
Router exists on your network, select Router. When
Router is chosen, Dynamic Routing will be available as an
option.
Dynamc Routng
This feature enables the Router to
automatically adjust to physical changes in the network's
layout and exchange routing tables with the other router(s).
The Router determines the network packets' route based
on the fewest number of hops between the source and
the destination. This feature is Dsabled by default. From
the drop-down menu, you can also select LAN & Wreless,
which performs dynamic routing over your Ethernet and
wireless networks. You can also select WAN (Internet),
which performs dynamic routing with data coming from
the Internet. Selecting Both enables dynamic routing for
both networks, as well as data from the Internet.
Statc Routng
To set up a static route between the Router
and another network, select a number from the Static
Routing drop-down list. (A static route is a pre-determined
pathway that network information must travel to reach a
specific host or network.) Enter the information described
below to set up a new static route. (Click the Delete Ths
Entry button to delete a static route.)
Enter Route Name Enter a name for the Route here,
•
using a maximum of 25 alphanumeric characters.
Destnaton LAN IP
The Destination LAN IP is the
•
address of the remote network or host to which you
want to assign a static route.
Subnet Mask The Subnet Mask determines which
•
portion of a Destination LAN IP address is the network
portion, and which portion is the host portion.
Wreless-G Broadband Router wth SpeedBooster
Advanced Configuration
Default Gateway This is the IP address of the gateway
•
device that allows for contact between the Router and
the remote network or host.
Interface
This interface tells you whether the
•
Destination IP Address is on the LAN & Wreless
(Ethernet and wireless networks) or the WAN
(Internet).
Click the Show Routng Table button to view the Static
Routes you have already set up.
Click the Save Settngs button to apply your changes, or
click the Cancel Changes button to cancel your changes.
Wireless > Basic Wireless Settings
The basic settings for wireless networking are set on this
screen.
Wireless > Basic Wireless Settings
Wireless Network
Wreless Network Mode
From this drop-down menu,
you can select the wireless standards running on your
network. If you have both 802.11g and 802.11b devices
in your network, keep the default setting, Mxed. If you
have only 802.11g devices, select G-Only. If you have
only 802.11b devices, select B-Only. If you do not have
any 802.11g and 802.11b devices in your network, select
Dsable. SpeedBooster works automatically with all
settings, providing the added bonus of increased speed
across your entire network and even greater speed when
you use SpeedBooster products only.
NOTE: SpeedBooster
Infrastructure Mode.
Wreless Network Name (SSID)
name shared among all points in a wireless network.
The SSID must be identical for all devices in the wireless
network. It is case-sensitive and must not exceed
32 characters (use any of the characters on the keyboard).
Make sure this setting is the same for all points in your
ONLY works in
The SSID is the network
8