Threading; Bobbin Winding; Spool Cone Holder; Spool Pin - Baby Lock Quilter's Choice Professional BLQP Instruction And Reference Manual

Threading (1)

Bobbin Winding

Do not move bobbin winding clutch while machine
is running.
3
4
3
3 Pass the thread through the triangu-
lar hole.
Note
1
2
5 - 0: See the following illustrations.
4 Pass thread through bobbin winding
thread guide as shown in drawing.
✽1
Spool Cap
Spool of Thread
1 Raise the thread guide bar all the way.
2 Mount a spool thread on the spool pin.
✽1 Use spool cap when using parallel-wound thread.
✽2 Use spool cone holder to stabilize cone shaped spools of thread.
Thread Notch 1
Thread Notch 2 Bobbin
Bobbin Winder
Shaft
Guide Pin
5 Run thread through top thread notch
1, and align bottom thread notch 2 of
the bobbin with guide pin on bobbin
winder shaft.
✽2
2

Spool Cone Holder

Bobbin Winding Clutch
6 Press bobbin winding clutch up
against empty bobbin. If the bobbin
stop does not slide easily between
the top and bottom of the bobbin,
check that the bobbin is seated prop-
erly with the guide pin (5) inserted
into the lower notch.
1
7