Baby Lock Embroidery Professional BMP8 Instruction And Reference Manual page 192

■ Adjusting the cap frame driver
1 L-shaped bracket
2 Ring
Memo
● If the same machine is being used, the
adjustment to the cap frame driver is only
required the first time that the machine is
used.
Turn on the machine. After the carriage
1
moves to its initial position, turn off the
machine.
Note
● Be sure to adjust the cap frame driver with
the carriage at its initial position.
2 Using the Allen screwdriver (medium), loosen
the two hexagonal screws. Loosen the screws
only by about one turn.
1 Hexagonal screws
2 Allen screwdriver (medium)
Note
● Do not loosen them too far.
3 Lower the L-shaped bracket to make it touch
the machine bed and then tighten the two
hexagonal screws using the Allen screwdriver
(medium). Firmly tighten the screws.
1 L-shaped bracket
4 Using the Allen screwdriver (large), loosen the
four hexagonal screws on the inside of the
ring. Loosen the screws only by about one
turn.
1 Hexagonal screws
2 Allen screwdriver (large)
When the screws are loosened, the ring can
be lowered.
Note
● Do not loosen them too far.
Using the Optional Cap Frame
7
175