Bobbin Winding; Removing The Bobbin; Winding The Bobbin - Baby Lock A-Line Audrey BL67 Instruction And Reference Manual

BOBBIN WINDING

REMOVING THE BOBBIN

1.Remove the bobbin cover by sliding the
release lever to right and push down
the left corner of bobbin cover at the
same time.
2.Remove the bobbin from the machine.

WINDING THE BOBBIN

1
1.Raise presser foot lever.
Pivot spool pin into highest position.
Place a spool of thread on the spool pin.
Secure it with the spool cap to ensure smooth flow of thread.
Use a spool cap closest in size to the spool of thread being used.
2.Pass thread from spool through thread guides as shown.
3.Pull end of thread through hole in bobbin as shown.
4.Move bobbin winder shaft to the left. Place bobbin onto shaft and rotate till it snaps
into position with the end of thread coming from top of bobbin. Push bobbin winder
shaft to right until it clicks. Hold onto end of thread.
5.Start machine to wind the bobbin. Stop machine after a few turns to trim the
thread tail with scissors. Bobbin will stop turning when completely filled.
Cut the thread and push shaft to the left to remove bobbin.
2
3
1
4
-11-
2
5