Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 110

14C Keyboard Sync: Determines how subsequent notes are affected by modulation. For a setting of
OFF, modulation is applied to subsequent notes in the same way it is currently being applied to
notes that are already held down. That is, subsequent notes (or Note On message) will not be
affected by the Delay parameter. For a setting of ON, modulation restarts for each new note.
15A–15D After Touch & Joystick Control
These parameters determine how a Program responds to After Touch, VDF Modulation MIDI
Controller2 and Pitch Bender.
15A AFT CTRL ø
P.Bend+12 Fc+00
15A
LCD Parameter
After Touch Pitch Bend
(P.Bend)
15A
After Touch VDF Cutoff
Frequency (Fc)
After Touch VDF MG
Intensity (VDF.MG)
15B
After Touch VDA
Amplitude (Amp)
Joystick VDF MG
15C
Intensity (VDF.MG)
Joystick Pitch Bend
Range (P.Bend)
15D
Joystick VDF Sweep
Intensity (VDF)
15A After Touch Pitch Bend: This parameter determines the After Touch pitch bend range (within 1
octave).
After Touch VDF Cutoff Frequency: This parameter determines how the VDF Cutoff Frequency
responds to After Touch. For positive values, After Touch increases the Cutoff Frequency, thus
making the sound brighter. Negative values have the opposite effect. For this parameter to have
any affect, you must set the VDF Cutoff Frequency to something other than 99.
15B After Touch VDF MG Intensity: This parameter determines how VDF modulation responds to
After Touch. When After Touch is applied, the VDF Cutoff Frequency is modulated. (see
"14A–14C VDF Modulation" on page 96.)
After Touch VDA Amplitude: This parameter determines how the VDA responds to After Touch.
In other words, how After Touch affects the volume of Oscillator1. For positive values, increasing
After Touch (pressing down on a held key) increases the volume. Negative settings have the
opposite effect.
15B AFT CTRL ø 15C J.STK Down ø
VDF.MG00 Amp+00 VDF.MG=99
15B
Range
–12...+12
–99...+99
0–99
–99...+99
0–99
–12...+12
–99...+99
15D BEND CTRL
P.Bend+00 VDF+00
15C
Description
After touch pitch bend range
VDF Cutoff Frequency sensitivity to After Touch
VDF modulation sensitivity to After Touch
VDA1 sensitivity to After Touch
VDF modulation sensitivity to the VDF Modulation MIDI
Controller2
Pitch bend range and direction
VDF modulation sensitivity to the VDF Modulation MIDI
Controller Pitch Bendor
Reference Guide
ø
15D
97
1
Program
Parameters