Power Management Setup - Gigabyte GA-P61-S3-B3 User Manual

SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Start detecting at Port.....
Part1-2 Status = Open / Length =
Part3-6 Status = Open / Length =
Part4-5 Status = Open / Length =
Part7-8 Status = Open / Length =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
2-7

Power Management Setup

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
ACPI Suspend Type
Soft-Off by PWR-BTTN
PME Event Wake Up
Power On by Ring
Resume by Alarm
x Date (of Month) Alarm
x Time (hh:mm:ss) Alarm
HPET Support
(Note)
HPET Mode
(Note)
Power On By Mouse
Power On By Keyboard
x KB Power ON Password
AC Back Function
ErP Support
: Move Enter: Select
F5: Previous Values
ACPI Suspend Type
Specifies the ACPI sleep state when the system enters suspend.
S1(POS) Enables the system to enter the ACPI S1 (Power on Suspend) sleep state.
In S1 sleep state, the system appears suspended and stays in a low power mode.
The system can be resumed at any time.
S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state (default).
In S3 sleep state, the system appears to be off and consumes less power than in the
S1 state. When signaled by a wake-up device or event, the system resumes to its
working state exactly where it was left off.
(Note) Supported on Windows 7/Vista operating system only.
BIOS Setup
SMART LAN
0m
0m
0m
0m
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Power Management Setup
[S3(STR)]
[Instant-Off]
[Enabled]
[Enabled]
[Disabled]
Everyday
0 : 0 : 0
[Enabled]
[32-bit mode]
[Disabled]
[Disabled]
Enter
[Soft-Off]
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 32 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults