Table of Contents
Advertisement
7) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by Intel H67 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connec-
tors with the SATA2_2/3/4/5 connector
instructions on configuring a RAID array.
8) SATA2_2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Inel H67 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The Intel H67 chipset supports RAID 0, RAID 1,
RAID5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur-
ing a RAID array.
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
•
PORT
DEBUG
drives are to be used, the total number of hard drives must be an even number.
PORT
A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
•
DEBUG
does not have to be an even number.)
A RAID 10 configuration requires four hard drives.
•
(Note)
When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system perfor-
mance of the RAID set may vary depending on the devices being connected.
Hardware Installation
. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for
(Note)
SATA3_0
7
7
SATA3_1
PORT
DEBUG
PORT
DEBUG
SATA2_4
7
7
SATA2_5
PORT
DEBUG
PORT
DEBUG
- 24 -
Pin No. Definition
1
GND
1
2
TXP
3
TXN
1
4
GND
5
RXN
6
RXP
7
GND
Pin No. Definition
1
GND
SATA2_2
2
TXP
1
3
TXN
1
4
GND
SATA2_3
5
RXN
6
RXP
7
GND
Please connect the L-shaped end of the
SATA cable to your SATA hard drive.
Advertisement
Table of Contents
