Usb Controller - Gigabyte GA-G31M-S2L User Manual

SATA Port 1/3 Set to
This value is dependent on the On-Chip SATA Mode and PATA IDE Set to settings.
When PATA IDE Set to is configured to Ch. 0 Master/Slave, this option will be automatically set
to Ch. 1 Master/Slave.

USB Controller

Enables or disables the integrated USB controller. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB 2.0 Controller
Enables or disables the integrated USB 2.0 controller. (Default: Enabled)
USB Keyboard Support
Allows USB keyboard to be used in MS-DOS. (Default: Disabled)
USB Mouse Support
Allows USB mouse to be used in MS-DOS. (Default: Disabled)
Legacy USB storage detect
Determines whether to detect USB storage devices, including USB flash drives and USB hard
drives during the POST. (Default: Enabled)
Azalia Codec
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item
to Disabled.
Onboard H/W LAN
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
SMART LAN (LAN Cable Diagnostic Function)
Start detecting at Port.....
Pair1-2 Status =
Pair3-6 Status =
Pair4-5 Status =
Pair7-8 Status =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show
Open and the Length fields show 0m, as shown in the figure above.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Open / Length
Open / Length
Open / Length
Open / Length
+/-/PU/PD: Value
F6: Fail-Safe Defaults
SMART LAN
= 0m
= 0m
= 0m
= 0m
F10: Save
- 41 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup