Fluke 373 Calibration Manual page 11

Use caution around bare conductors or bus bars. To prevent
electrical shock, do not touch the conductor.
Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face
protection, and flame-resistant clothes) to prevent shock
and arc blast injury where hazardous live conductors are
exposed.
Disconnect power and discharge all high-voltage capacitors
before you measure resistance or continuity.
Do not measure ac/dc current in circuits carrying more than
600 V or 200 A with the Product Jaw.
Do not operate the product with covers removed or the case
open. Hazardous voltage exposure is possible.
When white wear indicator insulation shows through the
clamp cable jacket, replace the clamp cable.
Do not exceed the Measurement Category (CAT) rating of
the lowest rated individual component of a product, probe,
or accessory.
Measure a known voltage first to make sure that the Product
operates correctly.
To prevent possible damage to the product or to equipment
under test:
Use the correct terminals, function, and range for
measurements.
Clean the case and accessories with a damp cloth and mild
detergent only. Do not use abrasives or solvents.
W Caution
Clamp Meter
Safety Information
3