Adjusting The Direction Of Air Circulation - Fujitsu ASTG09LVCA Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

Vertical (up-down) direction of airflow is adjusted by pressing the Remote Controller's SET button. Horizontal (right-left) Airflow
direction is adjusted manually, by moving the Airflow Direction Louvers.
Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical Airflow direction
louvers are stopped.
Vertical Airflow Direction Adjustment
Press the SET button (Fig. 5 P).
Each time the button is pressed, the Airflow direction range will change as follows:
1
Types of Airflow Direction Setting:
1,2,3 :
During Cooling/Dry modes
4,5,6 : During Heating mode
The Remote Controller's display does
not change.
G Use the Airflow direction adjustments within the ranges shown above.
G The vertical Airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry mode : Horizontal flow 1
During Heating mode
G After beginning of AUTO/HEAT mode operated and automatic defrosting opera-
tion time (see page 16), the airflow will be horizontal 1.
However, the Airflow direction cannot be adjusted at beginning AUTO operation mode.
Right-Left Adjustment
Adjust the Right-Left louvers.
G Move the Right-Left louvers to adjust air flow in the direction you prefer.
knob
(two places)
2 3 4 5
: Downward flow 5
Right-Left Louvers
knob
R DANGER!
G Never place fingers or foreign objects in-
side the outlet ports, since the internal fan
operates at high speed, and personal injury
could be caused.
6
G Always use the Remote Controller's
G During use of the Cooling and Dry
G When used in a room with infants, chil-
R DANGER!
G When adjusting the Right-Left Louvers, it
is necessary to stop the Air-Conditioner
first and make sure that it stops completely
before adjusting the direction.
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper
operation; in this case, stop operation
and restart. The louvers should begin
to operate properly again.
modes, do not set the Airflow Direc-
tion Louvers in the Heating range (4 -
6) for many hours, since water vapor
may condense near the outlet louvers
and drops of water may drip from the
indoor unit. During the Cooling and
Dry modes, if the Airflow Direction
Louvers are left in the heating range
for more than 30 minutes, they will
automatically return to position 3.
dren, elderly or sick persons, the Airflow
direction and room temperature should
be considered carefully when making
settings.
En-10