To Secure Rear Standing Child; To Use Jump Seat - Baby Trend Sit N Stand Plus Instruction Manual

TO SECURE REAR STANDING CHILD

1. The rear platform and jump seat are designed to accommodate a child
who is at least 2 1/2 years old, has good balance and coordination, and is
not over 40 inches tall. Position the child on the platform on the back of
the stroller. Be sure child is facing forward and hands are holding frame.
Secure the safety belt behind child and engage buckle. Fig. 12.
2. Be sure that the child's feet are fully on the platform at all times.
PLEASE NOTE: When using the rear SEAT you must put the STAND
FEATURE SAFETY BELT in the storage location located on the rear of
the seat. Please See Fig. 12A
WARNING:
choking hazzard when using the rear seat, put
the STAND FEATURE SAFETY BELT in the
storage location on the rear of the seat.
Fig. 12.
STEP ONE: REMOVING THE REAR SEAT
1. Remove the rear canopy by sliding the square fittings upward until they
disconnect from the frame.
2. Remove the rear seat from the frame by un-buttoning the upper and lower
seat back fabric from the frame (Fig. 13 & 14) and un-snaping both front
connection points. Fig. 15
3. Detach the (2) shoulder straps from the frame by folding and sliding the
strap through the "D-ring" located on the end of each strap. Fig. 16.
4. Detach the center crotch strap from the frame by folding and sliding the
strap through the "D-ring" located on the end of the strap. Fig. 17.
To avoid a possible
Fig. 12A.

TO USE JUMP SEAT

Fig. 12B.
Shoulder Strap
Waist
Squeeze
Strap
Adjust for a
Crotch Strap
Upper
Fig. 13
Snap point
Fig. 14
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 10.
Fig. 11.
snug fit
Lower
5