Asus P4B533-V User Manual page 52

4. Chassis intrusion connector (4-1 pin CHASSIS1)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you remove any chassis
component, the sensor triggers and sends a high-level signal to this
lead to record a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. If you wish to use the chassis intrusion detection
feature, remove the jumper cap from the pins.
P4B533-V
®
P4B533-V Chassis Alarm Lead
5. SMBus connector (6-1 pin SMB1)
This connector allows you to connect SMBus (System Management
Bus) devices. Devices communicate with an SMBus host and/or other
SMBus devices using the SMBus interface. SMBus is a specific
implementation of an I
chips to connect to the same bus and enable each one to act as a
master by initiating data transfer.
P4B533-V
®
P4B533-V SMBus Connector
2-26
CHASSIS1
(Default)
2
C bus, a multi-device bus that allows multiple
SMB1
1
Chapter 2: Hardware information