Table Of Contents; Unpacking; Features; Safety Precautions - American DJ FAB 4 User Instructions

Table of Contents

Advertisement

FAB 4™
Introduction...................................................................................2
Unpacking....................................................................................3
Features.......................................................................................3
Safety Precautions.......................................................................4
Set-Up....................................................................................5
DMX Addressing......................................................................6
Controls & Functions................................................................7
Operation..............................................................................8
Lamp Replacement..............................................................11
Cleaning...............................................................................12
Dip Switch Charts...............................................................12
DMX Traits...........................................................................13
Warranty.................................................................................14
FAB 4™
Every FAB 4™ has been thoroughly tested and has been shipped
in perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears
to be damaged, carefully inspect your fixture for any damage and be
sure all equipment necessary to operate the unit has arrived intact. In
case damage has been found or parts are missing, please contact our
toll free customer support number for further instructions, please do not
return the unit to your dealer.
FAB 4™
• 64 Vibrant Colored Beams.
• Linkable.
• Audio Sensitivity Knob.
• Uses One DMX Channels.
• Sound-Active.
• DMX-512 Protocol Compatible.
• Master/Slave Built-In Programs.
• Fan Cooled.
American DJ Supply
www.americandj.com FAB 4™ Instruction Manual Page 3
©
®
Contents
FAB 4™
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required voltage
for your unit.
• Do not attempt to operate this unit if the power cord has been frayed
or broken. Please route your power cord out of the way of foot traffic.
• Do not attempt to remove or break off the ground prong from
the electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the top cover under any conditions. There are no
user serviceable parts inside.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6" (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged in any way.
• Never operate this unit when it's cover is removed.

Unpacking

• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• This unit is intended for indoor use only, use of this product outdoors
voids all warranties.
• During long periods of non-use, disconnect the unit's main power.
• Always mount this unit in safe and stable matter.
• Power Cord Protection - Power supply cords should be routed
so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from
the appliance.

Features

• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer.
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances (includ-
ing amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits a
marked change in performance.
American DJ Supply
©

Safety Precautions

www.americandj.com FAB 4™ Instruction Manual Page 4
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents