Applying Power - DigiTech BP90 Owner's Manual

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
1. Turn the amp volume all the way down.
2. Connect the plug of the power supply to the power jack on the rear panel of the BP90.
3. Connect the other end of the power supply to an AC outlet. Use the Master Level but-
ton and the Value Up/Down buttons to set the BP90's Master Level to "0".
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a nor-
mal playing level.
5. Use the Master Level button and the Value Up/Down buttons to gradually increase the
BP90's Master Level to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
2. Connect the power adapter to power jack
BASS BASS BASS BASS
NOISE GATE NOISE GATE NOISE GATE NOISE GATE DELAY DELAY DELAY DELAY
CHORUS/FX CHORUS/FX CHORUS/FX CHORUS/FX
EQUALIZER EQUALIZER EQUALIZER EQUALIZER REVERB REVERB REVERB REVERB
AMP / DISTORTION AMP / DISTORTION AMP / DISTORTION AMP / DISTORTION EXPRESSION EXPRESSION EXPRESSION EXPRESSION
IN TUNE IN TUNE
COMPRESSOR COMPRESSOR COMPRESSOR COMPRESSOR COMPRESSOR COMPRESSOR PATTERN PATTERN PATTERN PATTERN
FRETLESS / WAH FRETLESS / WAH TEMPO TEMPO TEMPO
FRETLESS / WAH FRETLESS / WAH TEMPO
PRESET LEVEL PRESET LEVEL PRESET LEVEL PRESET LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL
VALUE VALUE
EDIT EDIT DRUMS DRUMS DRUMS DRUMS
STORE STORE
TONE LIBRARY EFFECTS LIBRARY EFFECTS LIBRARY EFFECTS LIBRARY EFFECTS LEVEL EFFECTS LEVEL EFFECTS LEVEL MASTER LEVEL MASTER LEVEL MASTER LEVEL
TONE LIBRARY TONE LIBRARY TONE LIBRARY EFFECTS LIBRARY EFFECTS LEVEL MASTER LEVEL
3. Connect the power adapter to
AC outlet and set the BP90's Master
Level to "0"
5. Set the BP90's Master Level to the
desired listening volume
15