Advertisement
DJ Scan™ Features cont.
internal programs. The DJ Scan™ can also be controlled via a standard DMX controller such as the
American DJ Show Designer,
over
the
gobo
Note: The built in programs in the DJ Scan are so good you may never need a DMX controller.
DJ Scan™ Customer Support
American DJ provides a toll free customer support line, to provide set up help and to answer any ques-
tion should you encounter problems during your set up or initial operation. You may also visit us on
the web at www.americandj.com for any comments or suggestions.
Service Hours Monday through Friday are 10:00 a.m. to 5:00 p.m. Pacific Time.
Voice (800) 322-6337
Fax
(323) 582-2610
E-mail: support@americandj.com
DJ Scan™ Set Up
Power Supply:
Before plugging your unit in be sure the voltage in your area matches the required voltage for your
unit. The DMX Operator™ require a DC 9v 200mA power supply.
The DMX Operator™ is available in a 115v and 230v version. Because line voltage may vary from
venue to venue, you should be sure to plug your power supply into a matching wall outlet before
attempting to operate you controller.
Data Cable (DMX Cable) Requirements:
Your fixture and your controller require a standard 3-pin XLR connector for data input and data output
(Figure 1). If you are making your own cables be sure to use standard two conductor shielded cable
(This cable may be purchased at almost all pro sound and lighting stores). Your cables should be
made with a male and female XLR connector on either end of the cable. Also remember that DMX
cable must be daisy chained and can not be "Y"ed or split.
Notice:
Do not use the ground lug on the XLR connector. Do not connect the shield conductor
to the ground lug or allow the shield conductor to come in contact with XLR outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
or the American DJ
™
and
color
wheel
. Los Angeles, CA. 90058 USA DJ Scan Page 2
American DJ Supply
®
DMX Operator,
®
as
well
as
the
giving the user independent control
™
mirrors
pan
and
Figure 1
tilt
movements.
Advertisement
