Table of Contents
Advertisement
3. Entering and exiting the adjustment process mode
1) Before entering the adjustment process mode, the AV position RESET in the video adjustment menu.
2) While holding down the "VOL (–)" and "INPUT" keys at a time, plug in the AC cord of the main unit to turn on the power.
The letter "<K>" appears on the screen.
3) Next, hold down the "VOL (–)" and "CH (
(The "VOL (–)" and "CH (
Multiple lines of white characters appearing on the display indicate that the unit is now in the adjustment process mode.
When you fail to enter the adjustment process mode (the display is the same as normal startup), retry the procedure.
4) To exit the adjustment process mode after the adjustment is done, unplug the AC cord from the outlet to make a forced shutdown. (When the
power was turned off with the remote controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.)
CAUTION: Use due care in handling the information described here lest your users should know how to enter the adjustment process mode. If the
settings are tampered in this mode, unrecoverable system damage may result.
4. Remote controller key operation in adjustment process mode
Basic operation
Selecting the receiving channels
* Using the CH (
)/(
) keys, turn up and down an actual receiving channel.
Snap press: The channels are turned up and down one by one.
Continuous press: The next receivable channel is searched.
* Various adjustments: The items are adjusted one by one by selecting on the menu screen and using the cursor key and VOL (+) (–) keys.
* With the CURSOR UP/DOWN keys, select an adjustment item.
* Using the MENU key, the adjustment items are selected one after another. When the bottom item on a page is already selected and the MENU key
is pressed, the top item on the next page is selected.
* If any item on a page is selected and the preset key is pressed, the top item on the next page is selected.
Page1- Page2- Page3- Page7- Page9- Page10...
* If any item on a page is selected and the manual memory key is pressed, the top item on the same page is selected.
* Using the CURSOR LEFT/RIGHT keys and VOL (+) (–) keys, turn up and down the setting of a selected item.
Hierarchical shift
* When the ENTER key is pressed on any item other than I2C DATA on page 2, the setting page of the item shows up.
* To quit the setting page, press the front screen key.
)" keys at a time.
)" keys should be pressed and held until the display appears.)
LC-32D47U/LC-32SB27U/LC-C3237U
5 – 12
Hide quick links:
Advertisement
Table of Contents
