Sharp LC32SB27U - LC - 32" LCD TV Service Manual page 23

2.2.3 How to upgrade the software
1. Unplug the AC cord.
2. Insert the USB Memory for version upgrade (prepared as above) into the service socket located Right side of Main Board terminals, under INPUT3
terminal.
3. Plug in the AC cord with power button pressed down after 5 seconds, releases the power button.
4. After the unit startup, the system upgrade screen as shown below appears within 10-40 seconds.
5. Even a single failure in the process will trigger the upgrade failure screen.
NOTE: In the event of a failure, repeat the upgrade process. If the process repeatedly fails, it is likely that the hardware need fixing.
6. Upon completion of the whole process, the upgrade success screen as shown below appears. You can check the new software version on this
screen. The version information appears after the upgrade is complete.
7. Unplug the AC cord and remove the USB Memory for version upgrade.
8. Now the software version upgrade is complete.
NOTE: When you are done with the software version upgrade, start the set, go to the top page of the adjustment process screen and check the main
software version information.
Software Update Software Update
Failed to complete update. Failed to complete update.
Retry Software Update. Retry Software Update.
If system update fails again, If system update fails again,
contact the customer service center. contact the customer service center.
5 – 2
LC-32D47U/LC-32SB27U/LC-C3237U
4
ARTEMIS1 ARTEMIS1 4
4