Triton T1/PRI PRI and T1/E1 PRI Boards (PCI)
Models:
ALTI-TTT1-1
ALTI-T1E1-1
Green LED
OFF
ON
OFF
ON
OFF
Alternating
*Faulty signals include the following: yellow alarm, bipolar violation, or frame error.
Installing Channel Service Unit (CSU) to the Triton T1 or T1/E1 /PRI Board
1. Connect the CSU (Adtran model T1 CSU ACE used as an example) to the T1/
PRI or T1/E1PRI board using an RJ-48C or RJ-48X cable.
2. Connect the CSU to the network termination box using an RJ-48C or RJ-48X
cable.
AltiGen T1 Socket (RJ-48)
Pin 1=Receive Ring (INPUT)
Pin 2=Receive Tip (INPUT)
Pin 4=Transmit Ring (OUTPUT)
Pin 5=Transmit Tip (OUTPUT)
Software enabled for T1/PRI support. Delivers 24
channels of call processing and 24 full voicemail
ports.
1 T1, 1 E1, or 1 PRI
LED Indicators
Red LED
OFF
No power
OFF
Normal operation
ON
No signal
Flashing
Faulty signal with frame
synchronization*
Flashing
Faulty signal without frame
synchronization
Alternating
Frame slips in normal operation
Refer to your CSU manufacturer's manual for the proper pinout.
Status