Overview; About This Guide; How To Use This Guide; Before You Start - AT&T PagePac Plus AmpliCenter Installation And Use Manual

About This Guide

How to Use This Guide

Before You Start

1-2 Overview

The PagePac Plus AmpliCenter Installation and Use Manual explains the
features of the AmpliCenter, how to install and configure the AmpliCenter,
and interface to a communication system and other auxiliary equipment.
It is intended that PagePac Plus be installed by a trained telephone, audio,
or electrical installer with basic electronic knowledge. PagePac Plus
conforms to common installation practices and preferences found within
the Telcom Electrical and Commercial Sound installers manual.
Overview. This section provides an overview of AmpliCenter features
and capabilities, specifications, and a summary of installation steps for
the experienced installer.
If you are installing the PagePac Plus AmpliCenter for the first time,
you should read this entire guide before getting started to familiarize
yourself with the features.
Hardware Configuration. This section describes and illustrates the
AmpliCenter D20, D100, and D300 units.
Installing the Hardware. This section provides instructions for
mounting the PagePac Plus AmpliCenter hardware on a wall or in a
standard 19" equipment rack. Complete, detailed instructions for
connection and operation with telephone systems, music source,
speakers, and any control device inputs or outputs is provided.
Maintenance and Customer Support. This section gives some basic
troubleshooting tips if a paging zone does not operate properly after
connection to the AmpliCenter. Should a problem arise which requires
technical assistance, call AT&T technical support groups at the
numbers listed in this section.
Use the Contents and Index to locate specific items of interest.
Before installing your system, read and understand the safety instructions
in section 3. Be sure you have all the necessary parts— see Shipping
Container Contents, below. In addition, see Tools Required in section 3
for a few tools and test equipment that will be needed for installation.