Specifications; 1-10 Overview - AT&T PagePac Plus AmpliCenter Installation And Use Manual

Specifications

Table 1-2. AmpliCenter Specifications
D20: up to 20 Watts total speaker load
Capacities
D100: up to 100 Watts
D300: up to 300 Watts
All models: 3-1/2" (8.9 cm) high x 19" (48.25 cm) wide x 5" (12.7 cm) deep
Dimensions and
Weights
D20: 5 lbs (11 Kg) , D100 and D300: 6 Ibs (13 Kg)
Talk battery: 24 volts, loop start or ground start, negative voltage ring lead
RJ-11 Jack

Specifications

Impedence: 600
-10 to +40 deg. C. (14°F to 104°F) operational; to +50 deg. C. (122°F) with forced air
T e m p e r a t u r e
Range:
-20 to +70 deg. C. (28°F to 158°F) storage and shipment
5% to 95% (non-condensing) storage/shipment and operation
Humidity Range:
Locate in an area free of excess moisture, corrosive gases, dust, and chemicals.
Environmental
Requirements
100-250 VAC, 50/60 Hz, lamp, 3-prong outlet separate ground
Electrical
Outlet must not be controlled by an on/off switch
Grounding:

1-10 Overview

A. Use the power cord supplied with the unit, or an equivalent cord that meets applicable
safety codes. Do not cut or remove the third wire ground prong.
B. The attachment-plug receptacles in the vicinity of the product or system are all to be of a
grounding type, and the grounding conductors serving these receptacles are to be
connected to earth ground at the service equipment.