3Com 3C13701 Installation Manual page 61

The following figure shows the position of the SDRAM on the 3Com Router 5232.
Figure 43 Position of the SDRAM on the 3Com 5232
To ensure you can install the SDRAM correctly, there are two clips In the SDRAM slot
matching two concave points in the SDRAM card.
Removing the SDRAM
1 Locate the position of the SDRAM card on the main board.
2 Press the locking spring clips at both sides of the SDRAM slot outward with appropriate
strength to unseat the SDRAM.
Figure 44 Remove/install the SDRAM
3 Hold the SDRAM by its edges with your thumb and index finger and pull it out from the
slot. Put the SDRAM into an anti-static bag to avoid ESD damage.
CAUTION: To avoid damage to the SDRAM:
Hold the SDRAM by its edge and avoid touching the components on its surface.
■
Use firm but not forced pressure when removing the SDRAM.
■
Do not touch the components on the surface of the SDRAM with bare hands.
■
Hardware Maintenance 61