Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual page 42

2. PRINTER SETUP
2.9.1 Parameter Setting
(Cont.)
NOTE:
If the printer and the PC are
connected by USB, plug & play will
be automatically enabled, regardless
of the setting of this parameter.
(24) Centronics Interface Selection
This parameter is to choose the type of the Centronics interface operating
mode.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
CENTRO MODE
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the Centronics interface operating mode, press the
[PAUSE] key.
(25) Plug & Play Selection
This parameter is to choose whether to enable a Plug & Play function.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
PLUG & PLAY OFF
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting a Plug & Play, press the [PAUSE] key.
E2-28
2.9 Setting an Operating Environment
SPP
CENTRO MODE SPP
CENTRO MODE ECP
PLUG & PLAY OFF
PLUG & PLAY ON
ENGLISH VERSION EO1-33058
SPP: Compatible mode
ECP: ECP mode
Unavailable
Available