Table of Contents
Advertisement
THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICATED BELOW.
STEP 1 – PUMP LUBRICATION
This air compressor features an oil lubricated pump that requires the use of SAE 30 weight non-detergent air compressor oil.
Adding Compressor Oil:
1. Place air compressor on a flat, level surface.
2. Remove plastic oil fill
breather plug (see Fig. 1).
Fig. 1
CAUTION
CHECK OIL
LEVEL DAILY!
OIL LEVEL OK
REFILL OIL
IMMEDIATELY
17.4oz (515ml)
OIL CAPACITY:
Fig. 3
DO NOT OPERATE THE COMPRESSOR WITHOUT LUBRICANT, OR WITH LOW LUBRICATION LEVEL. THE MANUFACTURER IS NOT
RESPONSIBLE FOR DAMAGE CAUSED TO THE COMPRESSOR DUE TO OPERATION WITHOUT PROPER LUBRICATION.
ASSEMBLY INSTRUCTIONS
3. Open supplied oil bottle and pour oil into crankcase until the oil level reaches the center
of the red circle in the oil level sight glass (see Fig. 2). Be careful not to overfill.
Fig. 2
4. See diagram for determining proper oil fill level using oil fill sight glass
(see Fig. 3).
5. Install supplied plastic oil fill breather plug securely into oil fill hole.
9
Hide quick links:
Advertisement
Table of Contents
