Asus CUV4X-DLS User’s User Manual page 22

3. HARDWARE SETUP
6) SCSI Setting Jumper (3-pin SCSI_EN)
This jumper allows you to enable or disable the SCSI feature on the motherboard.
The default setting is ENABLE.
CUV4X-DLS
®
CUV4X-DLS SCSI Setting
7) USB Device Wake-up Jumpers (3-pin USBPWR1, USBPWR2)
These jumpers allow you to enable or disable the USB feature on the motherboard.
Set to ENABLE if you wish to use the USB devices to wake up the computer.
This feature requires an ATX power supply that can supply at least 2A on the
+5VSB lead. The default setting for both USBPWR1 and USBPWR2 is
DISABLE.
NOTES:
1. Before setting either of these jumpers to ENABLE, make sure that you have
the appropriate power supply, otherwise the computer does not power up.
2. The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal working conditions or in sleep mode.
CUV4X-DLS
®
CUV4X-DLS USB Device Wake-Up
22
ASUS CUV4X-DLS User's Manual
SCSI_EN
1 2 2 3
Enable
Disable
(Default)
USBPWR1
1
2
2
3
Disable Enable
(Default)
USBPWR2
1 2
2 3
Disable Enable
(Default)