Identify Your Door Type - Allstar MVP Installation And Owner's Manual

ASSEMBLY INSTRUCTIONS
STEP 6:
Position the open and close Limit Switch
Actuators to accept the Limit Cams on the chain, as
shown. Install the Chain Guard by sliding the
key-shaped hole onto the groove on the Idler Sprocket
Shaft and fully seating the rear hole over the Drive
Sprocket Shaft. The Limit Cams are installed at the
factory. Their settings should be considered
temporary and may be changed as required during
installation.
STEP 7:
Install the Rubber Bumper into its
mounting hole on the Tee Rail (see illustration above
for location). Secure the Bumper to the bottom of the
Tee Rail using one 5/16"-18 X 1" hex head bolt and
MASTER
104364
LINK
OUTER
INNER
CHAIN
NUT
NUT
Assembly is now complete and you are ready to begin installation of the opener.
DOOR TYPE IDENTIFICATION
IDENTIFY YOUR DOOR TYPE FROM THOSE ILLUSTRATED BELOW AND
FOLLOW INSTRUCTIONS FOR THAT TYPE OF DOOR
ONE PIECE DOOR
SECTIONAL DOOR
HORIZONTAL TRACK
CURVED TRACK
JAMB HARDWARE
HIGH ARC OF
DOOR TRAVEL
DOOR
TRACK
104367
FOR THESE TYPES OF DOORS USE
MODEL MVP OR MODEL MVP-SB.
USE 7 FT, 8 FT OR 10 FT RAIL
(MATCH DOOR HEIGHT)
HARDWARE USED TO BALANCE YOUR GARAGE DOOR
ARE UNDER EXTREME TENSION AT ALL TIMES AND CAN
CAUSE SEVERE INJURY OR DEATH IF DISTURBED.
WARNING
SPROCKET
SPROCKET
one 5/16"-18 washered nut (supplied) Tighten the bolt
a MAXIMUM of 1.5 turns after the bolt and nut are
snug.
STEP 8: Recheck
CHAIN
Rail to the Power Unit, making sure they are tight.
Recheck
and the position of both the Close Limit Switch and
Open Limit Switch Actuators.
MASTER
LINK
IMPORTANT!
ONE PIECE DOOR
NO TRACK
JAMB HARDWARE
HIGH ARC OF
DOOR TRAVEL
TRACK
DOOR
SPRINGS, PULLEYS, CABLES AND MOUNTING
DO NOT ATTEMPT ADJUSTMENT.
CLOSE LIMIT
SWITCH
ACTUATOR
CHAIN
GUARD
DRIVE
IDLER
the nuts used to secure the Tee
the Chain tension, Chain twist, Chain Guard
ONE PIECE DOOR
NO TRACK
PIVOT HARDWARE
HIGH ARC OF
HIGH ARC OF
DOOR TRAVEL
DOOR TRAVEL
DOOR
DOOR
JAMB
HARD-
PIVOT
WARE
THE MODEL MVP SERIES IN NOT
DESIGNED TO OPERATE THESE
TYPES OF DOORS
4
DOWN LIMIT
CAM
104366
104368